Older QEnergySpa/BEFE Array, Water Module
The B.E.F.E. Array was Q the Experience’ first mainstream Array. For those of you who may still be using it, below is a step-by-step illustration on how to change the Rings and Track of this water module.
|
|
Step 1
Remove the stainless steel Track from the Plates by swinging outwards at an angle and then slide it downwards to extract it from the Top Acrylic Plate. If it is still in good condition, it will need to be unclipped from the Bottom Positive Plate. |
|
|
Step 2
Place 2 fingers through the holes in the Removable Leg assembly and gently pull it outwards horizontal to the unit. The old Positive Plates should come out with it, but if they don’t, gently remove them as well. |
|
|
Step 3
Slot the new Plates into the slots and gently slide the assembly back into place. Be sure to align the Plates correctly with the appropriate slots in the other Legs. If the assembly does not slot in correctly, do not force it. Double check to make sure that it is all correctly aligned. |
|
|
Step 4
Slot the top of the Track into the slot in the Top Plate and slide it up and in at the same time. Be sure that the Track contacts are sitting on the top of the Top Plate and the bottom of the Bottom Plate. The Track should click into place. |
 Completed Array |
|
Older QEnergySpa/Befe Array 2000 Water Module
The Array 2000 (water module) was QtheExperience’ second mainstream Array, it was shipped with the B.E.F.E. power supply model numbers: 3006, 3024B, 3024D and 2100’s. Below is the step-by-step illustration on how to change the Rings and Track.
|
|
Step 1
Remove the stainless steel track by unclipping it from the bottom positive ring. Swinging it outwards at an angle and slide it downwards to remove it from the top acrylic plate. |
|
|
Step 2
Gently slide the removable leg out (it is safer and easier to do this if the Array is on a table or flat surface). The 2 positive rings (the degraded pair) may or may not come out with the leg when you remove it. If not, gently slide them out horizontally. |
|
|
Step 3
Slot the new plates into the existing slots followed by gently sliding the leg back into place. Be sure to align the plates correctly with the appropriate slots in the other legs. If it does not go back together easily, DO NOT force it! Double check to make sure that the plates are seated correctly and there are no obstructions. |
 |
Step 4
Finally, slot the top of the track into the slot in the top of the Array. As you slide it into place, the section marked “A” should be on top of the top newly inserted plate and “B” should be underneath the bottom newly inserted plate. The track should audibly click’ into place. |
|
|
Clipping onto the Array
The end of the cable that attaches to the array has two connectors or clips. The negative one is black in colour and round in shape. This fits onto the round rod located in the centre protruding from the top of the array. The other is red and square. This fits onto the flat metal track on the outside of the top of the Array. |
|
|
|
Completed Array
Older QEnergySpa/Befe Model 3006
The B.E.F.E. (Bio-Electric Field Enhancement) Unit model 3006 was one of the first power supplies released to the public by Q Tech Laboratories. It was released in January of 1999.
Older QEnergySpa/Befe Model 3024
The B.E.F.E. (Bio-Electric Field Enhancement) Unit model 3024 was the second mainstream power supply released to the public by QtheExperience. The first revision was designated 3024B, followed later by a second revision designated 3024D. The 3024B was released September of 2001.
